Wednesday, October 16, 2019

Water Heater Carrollton TX

https://www.facebook.com/Carrollton-Water-Heater-287411321864583/
+Water Heater Carrollton TX 😍🤝
https://www.facebook.com/Carrollton-Water-Heater-287411321864583/

{How to [Drain] a Water Heater}

Part 1

Water Heater Prep

1- Turn off your water heater.

2- Allow the water in the water heater to cool before continuing.

Part 2

Water Heater Flow

1- Turn the cold water intake valve off.

2- Turn on a hot water tap in your house to remove excess water in the pipes.

3- Open the pressure relief valve on the tank.

Part 3

Garden Hose Drainage

1- Find a very long garden hose.

2- Test the length of the hose before continuing.

3- Assess whether your water heater sits above or below ground level.

4- Connect the pump, if this is necessary.

5- Connect the garden hose to the water heater drain valve.

6- Allow the water to pump out or drain out completely.

7- Catch some of the water in a bucket, if the water is going to escape into a drain.

Part 4

Water Heater Flushing

1- Assess the water in the bucket for evidence of sediment.

2- Flush the water heater, if there is a large amount of sediment.

3- Disconnect the garden hose, flip the pressure switch and turn your gas intake or electricity intake back on.

Thursday, August 22, 2019

Water Heater Carrollton TX

https://www.facebook.com/Carrollton-Water-Heater-287411321864583/

Water Heater Carrollton TX

How to Turn on a Water Heater

Starting a Modern Gas Water Heater

1
Set the temperature and On/Off controls to the right setting. Before starting the water heater, turn the temperature manipulate to the lowest setting. The On/Off manipulate will want to be switched to the "Pilot" setting.
2
Press the pilot igniter button down whilst starting a spark. While you're conserving down the pilot igniter button, press the spark generator. This have to create a spark that you can see thru the little glass window, showing you that the pilot mild is lit.
3
Keep pressing the pilot igniter button for 20-30 seconds. After you see the spark, don't let go of the pilot igniter button yet. Keep urgent it for 20-30 seconds so that it is capable to get hot ample before being released.
4
Turn the manage to On and the temperature to the favored setting. Switch the On/Off manipulate to "On." Then turn the temperature placing to your favored temperature. Most human beings set theirs to a hundred and twenty °F (49 °C). At this point, you need to be able to see flames via the small glass window.
ABOUT OUR COMPANY 😍
Water Heater Carrollton TX
http://waterheatercarrolltontx.com/
Call Us At: 469-701-0147

water_heatr_repair Water_heater_installation
commercial_plumber
residential_plumber
commercial_plumbing 24_hr_plumbing hot_water_tank Water_Heater_Carrollton_TX